• Turn on time synchronization
• Create the motion group
• Create a servo axis for integrated motion on an EtherNet/IP network
• Add and configure drives using Studio 5000 Logix Designer software
• Associate the servo axes to their drives
• Configure the axes
• Run hookup tests
• Test digital inputs
• Tune axes for integrated motion on an EtherNet/IP network
• Create user-defined data types for motion applications
• Use motion direct commands
• Use step sequence logic in integrated motion application code
• Program Motion Servo On(MSO)instructions
• Program Motion Servo Off(MSF)instructions
• Program Motion Axis Home(MAH)instructions
• Program Motion Axis Stop(MAS)instructions
• Program Motion Axis Jog(MAJ)instructions
• Program Motion Axis Shutdown(MASD)instructions
• Program Motion Axis Fault Reset(MAFR)instructions
• Program Motion Axis Shutdown Reset(MASR)instructions
• Program group motion instructions
• Program Motion Change Dynamics(MCD)instructions
• Program the merge feature for motion move instructions
• Add a virtual axis to a project
• Program Motion Axis Gear(MAG)instructions
• Program Motion Axis Position Cam(MAPC)instructions
• Program Motion Axis Time Cam (MATC) instruction

Prerequisites

To successfully complete this course, the following prerequisites are required: Motion Control Fundamentals course (Course No. CCN130). Studio 5000 Logix Designer Level 3: Project Development (Course No. CCP143)

Who Should Attend

Individuals who need to configure and program Logix 5000™ motion control systems should attend this course. In addition, only students who are already familiar with Logix 5000 systems and general motion control should attend this course.

To Register for E-Learning, please contact:

NORTH TEXAS – Brad Freeman at 817-422-6607

SOUTH TEXAS – Andrew Hultgren at 713-426-8414

LOUISIANA – Joe Boudreaux at 504-645-9155