• Understanding EtherNet/IP Network Addressing Fundamentals Assigning a Computer's IP Address for an EtherNet/IP Network
• Performing Initial Configuration of a Managed Switch
• Configuring EtherNet/IP Settings on Automation Devices
• Configuring DHCP Persistence for a Stratix Switch
• Configuring Network Address Translation (NAT) for a Stratix 5700 Switch
• Configuring Port Security and Traffic Monitoring for a Stratix 5700 Switch
• Monitoring EtherNet/IP Network and Device Status
• Managing a Stratix 5700 Switch Using a Studio 5000 Logix Designer Project
• Troubleshooting EtherNet/IP Network Problems
• Troubleshooting a Stratix 5700 Switch
• Updating Stratix 5700 Switch Firmware

Prerequisites

To successfully complete this course, the following prerequisites are required: Completion of Studio 5000 Logix Designer Level 1: ControlLogix System Fundamentals (Course No. CCP146) or equivalent experience, Completion of Studio 5000 Logix Designer Level 2: ControlLogix Maintenance and Troubleshooting (Course No. CCP153).

Who Should Attend

This course is intended for technicians and engineers who must deploy and maintain Industrial Automation and Control System (IACS) networks should attend this course.

To Register for E-Learning, please contact:

NORTH TEXAS – Brad Freeman at 817-422-6607

SOUTH TEXAS – Andrew Hultgren at 713-426-8414

LOUISIANA – Joe Boudreaux at 504-645-9155