CR306C002
GE* Actual product may vary from image
NEMA Rated Full Voltage Magnetic Starters. Three-Phase Magnetic Starters. Nonreversing. Non-combination. Open. NEMA Size 1 with Thermal Overload Relay. 600 Volts Maximum 50/60 Hertz. Continuous Amperage rating 27.
Details
MFG PART #:CR306C002
TRC Part #:GEDICR306C002
UPC #:783166356005
Inventory
$838.89 E
Details
MFG PART #:CR306C002
TRC Part #:GEDICR306C002
UPC #:783166356005
Inventory
Attributes
Features
Documentation
Attributes
Brand:GE
Type:Full Voltage Non-Reversing Non-Combination Magnetic
Series:CR306
Voltage Rating:600 VAC
Amperage Rating:27 A
Frequency Rating:50/60 Hz
Coil Voltage:110/115 to 120 VAC
Number Of Poles:3
Reset Type:Manual
Phase:3 ph
Connection Type:Pressure Screw
Overload Relay:(2) 3 Leg Block Type Bimetal
Enclosure Type:Open
Operating Temperature:-20 to 70 deg C
Dimensions:7 in H x 3.71 in W x 3.94 in D
Features
| Tool less contactor disassembly (sizes 00 to 4) - allows quick access for inspection and maintenance |
| Just release two retainers and pull a clip to get at magnet, coil and contacts |
| Saddle clamp terminals (sizes 00 to 1) - accommodate ring, spade and stripped wire leads and carry permanent stamped in identification |
| Staggered arrangement makes wiring easier and helps prevent shorting between phases |
| Current carrying components contact tips are weld-resistant silver cadmium oxide (fine silver on sizes 00 and 0 only) |
| Contacts are installed in a wedge configuration for positive make with minimum bounce |
| Visual trip indicator with manual reset - to avoid surprise restarts, reset occurs on arm upstroke so a tripped condition can't be overridden by holding the arm down |
| Manual weld check provides a convenient test against welding of overload relay contacts, just depress the weld check operator to trip the relay, run a simple continuity test across the relay contacts, then depress the manual reset to return the starter to service |
| Dual bimetals - anticipate overloads, responding to rising current and temperature with faster tripping on severe overloads for better motor protection, trip points are factory-calibrated for accuracy |
| +/-10% trip adjustment - by turning a dial in the overload relay face allows tuning the protection to the motor on the spot |